Florida State Certified
Sheet Metal Contractor
Licensing Information

489.105(3)(d) - "Sheet metal contractor" means a contractor whose services are unlimited in the sheet metal trade and who has the experience, knowledge, and skill necessary for the manufacture, fabrication, assembling, handling, erection, installation, dismantling, conditioning, adjustment, insulation, alteration, repair, servicing, or design, when not prohibited by law, of ferrous or nonferrous metal work of U.S. No. 10 gauge or its equivalent or lighter gauge and of other materials, including, but not limited to, fiberglass, used in lieu thereof and of air-handling systems, including the setting of air-handling equipment and reinforcement of same, the balancing of air-handling systems, and any duct cleaning and equipment sanitizing which requires at least a partial disassembling of the system.

489.111 - Licensure by examination -

• (1) - Any person who desires to be certified shall apply to the department in writing.
• (2) - A person shall be eligible for licensure by examination if the person:
  • (a) - Is 18 years of age,
  • (b) - Is of good moral character, and
  • (c) - Meets eligibility requirements according to one of the following criteria:
    
    
    • 1. - Has received a baccalaureate degree from an accredited 4-year college in the appropriate field of engineering, architecture, or building construction and has 1 year of proven experience in the category in which the person seeks to qualify. For the purpose of this part, a minimum of 2,000 person-hours shall be used in determining full-time equivalency.
      
      
    • 2. - Has a total of at least 4 years of active experience as a worker who has learned the trade by serving an apprenticeship as a skilled worker who is able to command the rate of a mechanic in the particular trade or as a foreman who is in charge of a group of workers and usually is responsible to a superintendent or a contractor or his or her equivalent, provided, however, that at least 1 year of active experience shall be as a foreman.
      
      
    • 3. - Has a combination of not less than 1 year of experience as a foreman and not less than 3 years of credits for any accredited college-level courses; has a combination of not less than 1 year of experience as a skilled worker, 1 year of experience as a foreman, and not less than 2 years of credits for any accredited college-level courses; or has a combination of not less than 2 years of experience as a skilled worker, 1 year of experience as a foreman, and not less than 1 year of credits for any accredited college-level courses. All junior college or community college-level courses shall be considered accredited college-level courses.